Water Hammer Valves / Fittings
Supply Stops 511-53-31-14WHA
- Product Type
- Supply Stop with Integral Water Hammer Arrester
- 1/2 FIP X 3/8 OD Comp X Water Hammer Arrester
- Lead-Free Brass
- Plated Handle
- Inlet Pipe Type
- Inlet Size
- Outlet Pipe Type
- Outlet Size
- 3/8 OD
- Box / Case
- 12 / 72
- Unit Weight (lbs.)
Instructions for 511-53-31-14WHA
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
NPT THREAD: Clean pipe threads and cover them with pipe dope or PTFE tape. Tighten firmly while gripping hex on end of valve. DO NOT OVER-TIGHTEN.
COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or insert may be required.
Position arrester at any angle.
Features and Benefits
Stops banging pipes!
With integral AA water hammer arrester.
Every valve is tested before leaving our factory.
They may build them with something else, but they fix them with these.