- Product Type
- Mini-Ball Tee
- 3/4 Fem. Solder X 1/2 OD Male Flare X 1/2 FIP
- Regular Brass
- Inlet Pipe Type
- Inlet Size
- Outlet Pipe Type
- Outlet Size
- 1/2 OD
- Branch Pipe Type
- Branch Size
- Box / Case
- 12 / 72
- Unit Weight (lbs.)
Instructions for 14-82-53
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
FEMALE SOLDER: Do not dismantle valve – solder in open position. Clean pipe and valve socket with emery cloth, & apply flux to both. Pipe must be square and bottomed in socket. DO NOT re-position valve after soldering. Clean with water and dry. Let cool before operating.
NPT THREAD: Clean pipe threads and cover them with pipe dope or PTFE tape. Tighten firmly while gripping hex on end of valve. DO NOT OVER-TIGHTEN.
MALE FLARE: Do not use pipe dope or PTFE tape. Tighten firmly with wrench. DO NOT OVER-TIGHTEN.
Features and Benefits
dahl can produce thousands of models of common and specialty end-of-line tees.
Need something special? Just ask for it and it will ship same or next day from dahl .
Every fitting is tested before leaving our factory.
TDS 350 (TEE 14-82-53).pdf