Water Hammer Valves / Fittings
Supply Stops 611-PRPX3-31-14WHA
- Product Type
- Supply Stop with Integral Water Hammer Arrester
- 1/2 F1960 x 3/8 OD Comp x Water Hammer Arrester
- Lead-Free Brass
- Plated Handle
- Inlet Pipe Type
- Inlet Size
- Outlet Pipe Type
- Outlet Size
- 3/8 OD
- Box / Case
- 12 / 72
- Working Pressure
- 250 PSI
- Working Temperature
Instructions for 611-PRPX3-31-14WHA
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
F1960 COLD EXPANSION CONNECTION FOR PEX-A ONLY: Follow tube manufacturer's instructions. Warning: Do not attempt to use PEX connections with Poly-B tubing or vice versa.
COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or insert may be required.
Position arrester at any angle.
Features and Benefits
Stops banging pipes!
With integral AA water hammer arrester.
Every valve is tested before leaving our factory.
They may build them with something else, but they fix them with these.