Water Hammer Valves / Fittings
Supply Stops 516SS-PX3-31-14WHA
- Product Type
- Supply Stop with Integral Water Hammer Arrester
- 1/2 Crimpex X 3/8 OD Comp X Water Hammer Arrester
- Lead-Free Brass
- Loose Key with Screwdriver Slot
- Inlet Pipe Type
- Inlet Size
- Outlet Pipe Type
- Copper Compression
- Outlet Size
- 3/8 OD Comp
- Branch Pipe Type
- Water Hammer Arrester
- Box / Case
- 12 / 72
Instructions for 516SS-PX3-31-14WHA
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
CRIMPEX (Crimp for PEX): Follow tube manufacturer's instructions. Warning: Do not attempt to use PEX connections with Poly-B tubing or vice versa.
COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or an insert may be required.
Position arrester at any angle.