Dahl Valve Limited

Hanger and Straps, Test Caps

Test Caps 9153

Product Type
Test Caps - Copper
Description
1" Test Caps, 10/bag
Material
Copper

Packaging Details

Qty/Bag
10
Box / Case
10 / 60

Dimensions

Unit Weight (lbs.)
0.0954

Instructions for 9153

Turn off water supply. Install product. Turn on water supply, check for leaks. assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.

NPT THREAD: Clean pipe threads and cover them with pipe dope or PTFE tape. Tighten firmly while gripping hex on end of valve. DO NOT OVER-TIGHTEN.

COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or an insert may be required.

COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or an insert may be required.

Submittal Sheet

TDS 306 (9151 to 9156).pdf