dahl Ask for it by nameĀ®

mini-ball™ Valves

mini-ball™Valves, Supply Stops 616SS-QG3-31 (Push-Fit)

Supply Stops 616SS-QG3-31 (Push-Fit)

Product Type
Supply Stop
Description
1/2 QUICK-GRIP X 3/8 OD Comp
Material
Lead-Free Brass

Specifications

Pattern
Angle
Finish
Plated
Operation
Loose Key with Screwdriver Slot

Inlet

Inlet Pipe Type
Copper, PEX, CPVC
Inlet Size
1/2

Outlet

Outlet Pipe Type
Copper Compression
Outlet Size
3/8 OD Comp

Packaging Details

Box / Case
12 / 72

Instructions for 616SS-QG3-31

Turn off water supply. Install product. Turn on water supply, check for leaks. assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.

QUICK-GRIP™ For 1/2" Copper, PEX or CPVC pipe, in accessible locations only. NOT for Kitec® , PEX-AL-PEX, Poly-B, plated pipe. Cut pipe & de-burr. Mark pipe 1-1/8" (2.9 cm) from end. (PEX only: Install pipe insert). QUICK-GRIP™ must be free of debris. Push valve onto pipe to the mark. Pull to test joint. Removal: Remove Locking Clip, depress end of QUICK-GRIP™, pull valve off.

COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or insert may be required.

Certifications


NSF/ANSI/CAN 372
NSF/ANSI/CAN 61: Q≤0.5

ASSE 1061